Search results

We had to raise the rpm with 6 cylinder too

the new one? i have never seen it. its in Vegas

their previous car was a subaru with a small blower(i didnt set it up) they wanted it to be turbo and there was just too much cost involved to convert to turbo so he bought a different car and did not know i dont do hondas--thats how it got here

Last Friday was out in the dunes and one of my friends had a rear control break open. The rear arm went sideways. We were 5 miles from camp and had lots of guys and tried to lift the rear end of the car--no way!!. The bracket found its way below the bolt. Have had an exhaust jack i bought years...

there are ground loops possible with some ecus. all powers must come from a "main relay" post ecu. so the switch pro should only power up the ecu input (nothing else) it would be common for folks to have this same wire power up the ecu also give power to the 86 coil side of the relays--you...

i dont know these guys or their contact info if you could please provide, then i will pass it on to my customer thanks

on post 152 10th pic there is a bolt hole in the side of the block that should be siliconed closed (both sides) or it lets sand in the bellhousing area

I have a customer that just bought a V6 turbo Honda project with DBW throttle and a fuel tech ECU. They are out of Vegas. I was wondering if any of you know someone that works with Fuel Tech ecus, tuning and or Honda that would want to take on a project like this??

I have a brand new kit. Normally $530 for $400. Flywheel, plate and hardware

Went to Mexico for a 1300 mile SXS ride a few weeks ago. 11 cars. One was a speed. I was concerned going 600 miles south of the boarder was not a good idea for him. But he had a great trip. He left the trip and drove asphalt for the last 300 miles because another guy had to leave trip early. I...

(y)

just because the tranny was rebuilt doesn't mean the shifter is set up correctly, the stops set right, or the cables are not what they should be have those checked out before you get another $5k tranny build

Subaru and S5, i use the clutch every shift, its just easier on my brain and my tranny. sure i could shift with the best of them without a clutch but i feel using the clutch is a slam dunk on every shift.

Thank you but i was looking at the 520 pioneer specs. no specs on that motor, my wife doesnt need to go any faster than 40 mph around the house LOL. The other one sounds like a lot of fun

State Farm sent a 4 page letter to the department of insurance asking for permission to raise home rates by 22% (from what i can tell is this is across the board, this is just not in the Palisades or Eaton fires "to avoid financial ruin" pass the mismanaged forest, hills and water tanks on the...

does anyone own one of these Honda Pioneers? they wont say HP in any documentation and was wondering how it is compared to the earlier Yamaha rhino 700? was looking at upgrading the wife's ranchmobile

i havent had one of those in a long time, but i ride a bike too what do you use and do you get lots of faults?

We have lots of power outages in my area. Edison shuts us down with big winds so we are not the next “paradise “. Everyone has built in fridges so there is no simple way to keep your fridge powered up. I have a whole house generator but my neighbors typically don’t. Will be installing a 6...

Haha! That’s because why would anyone be looking for a front plate when a car looks that great.? that is one killer pic!

I have plenty of stories...... but it was just last night at 9:30pm that prompted the new thread. my wife and i go to visit our grand kids in corona (her in her car, me on my bike). we leave at the same time going south on the 15 to Murrieta to go home. i start doing my typical 100-110 cruise...