Recent content by ranman5608

Thank you im very happy with how the dash and console came out as well i cant wait to see them in the car with the rest of the interior in place.

Thank you sir. Doors are nice but ill save that for the side by side crowd HAHA

Good day gentlemen! Have been making little progress on the car since its been so hot but I have time. a few updates 1. relocated the rear gearbox mount to in front of the bell housing mount and boxed it in 2. added a gusset plate and boxed in the front end to tie the bulk head into the chassis...

Thanks Brother bring it on by lol

Well gentlemen here we go again. Last trip of the season didn't go as well as one would hope. After about a week of heavy winds the dunes were absolutely perfect and un touched. But with that comes some dangers that require a higher level of attention. Well one of those dangers got us. While...

quadlock is the way to go tons of mounting solutions.

with my limited experience i have only ever seen a triple rate setup with the lightest on top then getting heavier towards the bottom. it wasn't until recently when i really started to dive into the shock tuning world that i have seen the light spring in the middle setup How does the math on...

A Little update as i forgot about this post. the last two trips taken with the new shock tune and coil setup was absolutely 100x better than before chop is almost gone but i had to sacrifice some bump zone control. So ill continue to experiment as I go. I did have one question though. check...

this is what you need to crimp that type of connector...

I like to use the ec3 or an xt-90 for higher amperage smaller stuff you aren't worried about being water proof. for heavier duty stuff HDP line from Deutsch has a few options.

take it to AJ

I do not see any reason to not add these. With the entirety of the back of that car welded together you would likely be able to eliminate this tube all together and still net the same rigidity. A lot of the DD cars i have run into have had the uglier flange version of this done without any issues.

havent has any issues with my cbr in the sand car or my old prerunner.

that makes sense. i know they used to machine parts for a few other manufactures like howe and pss i believe. so why not try and build some other stuff. do they still support you if you have any issues?

Right. we all know R&D = Rip off & duplicate.