Recent content by Funco4JM

Question for you turbo guys - Is your BOV a vent to atmosphere? If so, do you have a filter skin that goes over it or just leave it open?

Well I decided to take the car out for a day trip on one last HooRah before the summer engine updates... I found out the hard way that I put the axles on the opposite sides, spinning them in reverse from their normal rotation. I made it 25' from camp when the axle twisted. Question - Should...

Congrats on the purchase!

I carry insurance on my Funco and my son's Sonic Sand Car primarily for Liability exposure. Other than that, it would have to be stolen or a total loss. Everything else I self-insure. A big reason we're seeing carriers lower property coverage limits is the amount of property losses they're...

Coming along nicely!

I just went through this with my car. Order one off of amazon or one of the many different sites that make them.

Turning out awesome!

That is beautiful. Its coming out super nice.

Coming along nicely! Do you have a process you can share on wiring the CV bolts like that? I assume you would start with a single wire of "x" length and go through the first bolt, twist the end and extra length, then move to the next and so on?

Damn that is some cleeeeeeeean wiring on that dash...

Update - Well, I got the finished car out for the Funco Regatta and one additional weekend after. I put 124 miles on it Saturday and another 86 miles on the following Saturday. The good: I can't believe how amazing the 3" Kings are. I almost didn't do that upgrade, and I am so glad that I...

For a 15" wheel I believe so. You would have to go to a 17" to go with the 35" or 36" sizes.

I had a bada$$ LS1 built from Danzio in the past, and another LS1 built from CBM, both N/A and both ran awesome. It seems that when your stepping into the high dollar TT motors Redline is the go to. If I was spending that much on a motor, I would want the builder that is out in Glamis...

Correct, but the knuckle looks to be set up for heim and misalignment spacers on the bottom. The arm is uniball.

Are the Tatum knuckles set up for a Uniball lower or you changing that to a heim with misalignment spacers?